Burnham V8 Series Bedienungsanleitung PDF herunterladen (Seite 12)

100

SECTION II: KNOCKDOWN BOILER ASSEMBLY

A. REMOVAL OF BARE BOILER FROM SKID

1. Boiler is secured to skid with 4 bolts, 2 in front and

2 in rear of shipping skid, see Figure 3. Remove all

bolts.

Figure 3: Knockdown Boiler Removal from Skid

2. Tilt boiler to right and to rear. Using right rear leg

as pivot, rotate boiler 90° in a clockwise direction,

and lower left side of boiler to ﬂ oor. Tilt boiler and

remove skid.

B. MOVE BOILER TO PERMANENT POSITION

by sliding or walking.

C. TEST BOILER FOR LEAKS before installing

controls, trim, and jacket, and before connecting to

heating system.

1. Loosen nuts on tie rods until only ﬁ nger tight.

2. Install pressure gauge (at least 50 PSI capacity),

a hose to the city water and a valve in the supply

tapping. Plug remainder of tappings.

3. Fill boiler with water and apply a pressure of at least

10 PSI but no more than 50 PSI gauge pressure.

GNINRAW

reliobedisnitfelriaonsierehttahterussA

roftsettonoD.skaelrofgnikcehcnehw

.riadezirusserphtiwskael

4. Examine boiler carefully inside and outside for leaks

or damage due to shipment or handling.

D. DRAIN WATER FROM BOILER. Remove gauge,

valve and plugs from those tappings to be used. Leave

other tappings plugged or bushed according to Figure 5.

E. INSPECT JOINTS BETWEEN SECTIONS. All

joints are factory sealed. If there are any spaces due to

shipment or handling, seal them with boiler putty.

F. INSPECT FLUE COVER PLATES for tightness.

If loose, retighten mounting hardware. If ﬂ ue plate or

sealing rope is damaged, repair or replace as needed.

G. INSTALL AND SECURE CANOPY with gasket

and hardware provided to ensure gas tight seal — see

Figure 4.

Figure 4: Boiler Canopy Installation

1. Cut two (2) strips 13 ¾” long from the roll of gasket

insulation. Place one (1) strip across the top of the

front section and the other across the rear section as

shown in Figure 4.

2. Cut the remainder of the roll into two (2) equal

pieces. Place each piece along the sides, allowing

the ends to overlap the front and rear pieces.

NOITUAC

ybegakcolbyaweulfynawollatonoD

.teksag

3. Position canopy body within the retaining bar which

borders the ﬂ ueway openings on top of the bare

boiler block assembly.

ECITON

tfelgnicafebtsumtekcarbtroppustekcaJ

tonlliwtekcaJ.4erugiFees-reliobfoedis

.yltcerrocdetneirotonsitekca

rbfitif

4. Secure canopy to boiler with two (2) 1/4" - 20 x 3"

long carriage bolts, 1/4" ﬂ at washers and 1/4" - 20

wing nuts provided.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Burnham V8 Series Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserkocher Burnham V8 Series